To be used with Instructor's guide of the same title under call number TK 4660 G37 GUIDE 1997 and Quizzes under same title in the Circulation shelves under call number TK 4660 G37 QUIZZES 1997.

DVD 1 -- Topic 1 Gas Metal Arc Welding Basic, Course Overview -- Topic 2 Introduction to Gas Metal Arc Welding -- Topic 3 Safety & Health of Welders -- Topic 4 Installation, Setup & Maintenance of Equipment -- Topic 5 Surfacing Welds, Flat Position -- DVD 2 -- Topic 6 Square-Groove & Fillet Welds, Butt, Lap & T-joints, Flat Position -- Topic 7 Square-Groove & Fillet Welds, Butt, Lap & T-joints, Horizontal Position -- Topic 8 The Qulaity of Welds -- Topic 9 Square-Groove & Fillet Welds, Butt, Lap & T-Joints, Vertical Position, Down -- Topic 10 Square -Groove & Fillet Welds, Butt, Lap & T-Joints, Vertical Position, Up -- Topic 11 Metal Transfer & Shielding Gases -- Topic 12 Square-Groove & Fillet Welds, Butt, Lap & T-Joints, Overhead Position -- Topic 13 Single-V-Groove Weld, Butt Joint, Horizontal Position -- Topic 14 Single-V-Groove Weld, Butt Joint, Horizontal Position, Guided Bend Test -- DVD 3 -- Topic 15 Single-V-Groove Weld, Butt Joint, Vertical Position Down -- Topic 16 Single -V-Groove Weld, Butt Joint, Vertical Position Down, Guided Bend Test -- Topic 17 Single-V-Groove Weld, Butt Joint, Vertical Position Up -- Topic 18 Single-V-Groove Weld, Butt Joint, Flat Position -- Topic 19 Single-V-Groove Weld, Butt Joint, Overhead Position -- Topic 20 Fillet Welds, Lap & T-Joints, Horizontal Position -- Topic 21 Fillet Welds, Lap & T-Joints, Vertical Position Down -- Topic 22 Fillet Welds, Lap Joints, Flat Position with Spray Transfer -- Topic 23 Fillet Welds, Lap Joints, Horizontal Position with Spray Transfer -- Topic 24 Single-V-Groove Weld, Flat Position, with Spray Transfer.

This DVD set contains the Gas Metal Arc Welding Basic course, consisting of 24 modules. There are 19 skills modules and 5 modules dealing with essential theory. Two modules (topics 14 and 16) are devoted to performing AWS standard bend testing. There are also two modules at the end of the course (topics 25 and 26), that are intended to serve as practice sessions for the AWS entry level qualification tests on short circuiting transfer and spray transfer. Each module works toward developing the individual student from a position of relative inexperience to a point where they have the necessary skills to be qualified as an entry-level welder as defined in AWS EGH.0 and QC10.--Instructor Guide p. ii.

DVD

English or Spanish language